Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Replacing pivot pins on 853
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="tjheld" data-source="post: 48281" data-attributes="member: 6459"><p>I am having trouble with the taper pin on my S250. I removed the grease fitting. Loosened the bolt more than two turns. It feels like it is spinning free in the pin. I can see it turn when I look in the zerk hole. What do I do now? Second, do I strike the factory stud to push the tapered pin to the center of the loader? Also, my bolt/stud will not come out. Is it attached somewhere I can not see? Does the tapered pin get pushed inside the bobtach plate? Looks like a easy job, but I never seen it out or have any pics of what it looks like inside the cylinders. Thanks for the response</p></blockquote><p></p>
[QUOTE="tjheld, post: 48281, member: 6459"] I am having trouble with the taper pin on my S250. I removed the grease fitting. Loosened the bolt more than two turns. It feels like it is spinning free in the pin. I can see it turn when I look in the zerk hole. What do I do now? Second, do I strike the factory stud to push the tapered pin to the center of the loader? Also, my bolt/stud will not come out. Is it attached somewhere I can not see? Does the tapered pin get pushed inside the bobtach plate? Looks like a easy job, but I never seen it out or have any pics of what it looks like inside the cylinders. Thanks for the response [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Replacing pivot pins on 853
Top
