Reply to thread

Message: <blockquote data-quote="Kermode" data-source="post: 48095" data-attributes="member: 3305"><p>If I recall correctly, they are a taper fit into the end of the boom. Loosen the bolt on the outside half a dozen turns and then give it a sharp rap with a good sized hammer. If all goes well the pin will pop loose from the taper and slide into the Bobtach. Knock both of them into the Bobtach and remove. When you replace these pins, hit the end of the bolt every once in a while as you tighten it. They have to be really tight.</p></blockquote><p></p>