Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 25230" data-attributes="member: 82"><p>Angle grinder is all you need. Cut a link and buy a new link, easy! Just cut the larger section that the new link will replace (if that makes sense). Cut through it, pull the chain out then grind the end of the pins that hold the sides on and use a pin punch to knock the pins out. Install back in the chain case install a new link and you are set. The links are cheaper than i expected, i think a set i got for 3/8" chain were 80c each. Your machine will use larger chain though, but its just a guide.</p></blockquote><p></p>