Reply to thread

Message: <blockquote data-quote="RodNH" data-source="post: 47812" data-attributes="member: 4512">Tazza,The cylinder OD is about 5.5 inches so the ID should be around 4.5 inches or a little greater. It came off an old garbage truck some 30 years ago so I don't have the exact specs. I have never actually measured the cycle time but it is faster than on my tractor. I would guess the extend time is around 5 sec the way I use it. I don't normally use the high flow as the low flow seems to work just fine and I'm quite satisfied at that speed. I also only idle the skid, which is 1340 rpm, about half the WOT speed. That should equate to somewhere around 12 gpm in low flow. High flow for my S650 is around 15 gpm at idle speed (30 gpm at WOT).</blockquote>