Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Old problem popped back up?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="perry" data-source="post: 14021" data-attributes="member: 538"><p>Ken, this is your old post concerning my problem........</p><p><span style="color: #0000ff">The resistance off that coil is 10.6 ohms on my 853 and the coil is different then the 3rd valve coils. </span></p><p><span style="color: #0000ff">Also on the nut (that holds the coil to the stem) is marked "do not exceed 5 ft lbs when tightening" This is important when installing any of these coils as overtightening will distart the stem (piece with o rings on) and the needle will bind inside the stem. The last stem i bought for my 773 was $104.00</span></p><p><span style="color: #0000ff">My bucket tilt cylinder will move a inch or 2 with the safety valve locked, but the boom will barely move at all.</span></p><p><span style="color: #0000ff">Ken</span></p><p> </p><p><span style="color: #000000">Am I to understand the wires 'from' the coil should be 10.6 ohms.?</span></p></blockquote><p></p>
[QUOTE="perry, post: 14021, member: 538"] Ken, this is your old post concerning my problem........ [COLOR=#0000ff]The resistance off that coil is 10.6 ohms on my 853 and the coil is different then the 3rd valve coils. Also on the nut (that holds the coil to the stem) is marked “do not exceed 5 ft lbs when tightening” This is important when installing any of these coils as overtightening will distart the stem (piece with o rings on) and the needle will bind inside the stem. The last stem i bought for my 773 was $104.00 My bucket tilt cylinder will move a inch or 2 with the safety valve locked, but the boom will barely move at all. Ken[/COLOR] [COLOR=#000000]Am I to understand the wires 'from' the coil should be 10.6 ohms.?[/COLOR] [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Old problem popped back up?
Top