oil pressure sender

[donald73d]

I cannot seem to find the oil pressure sender on an 843 w/Isuzi? Its not obvious. The service and parts manual have not helped me (yet) find it.

 

[donald73d]

I think I located it. On the right side of the engine, almost touching the starter solenoid bracket. I put a jumper from the sender to a good ground. Turned switch to ON and no light. So I assume the bulb is bad?

 

[Tazza]

I think I located it. On the right side of the engine, almost touching the starter solenoid bracket. I put a jumper from the sender to a good ground. Turned switch to ON and no light. So I assume the bulb is bad?

Bulb or a bad connector in the wiring harness. Start with the bulb though.

 

[donald73d]

Bulb or a bad connector in the wiring harness. Start with the bulb though.

I will pull the gauge cluster and replace the bulbs and non working gauges.

 

[donald73d]

I will pull the gauge cluster and replace the bulbs and non working gauges.

No biggie, but how does the bulb come out of the socket? Its about the size of a Christmas tree light. I would like to test it today before I buy a new bulb tomorrow. But I will replace the bulb anyway, but I would be farther ahead if I could test it. I tried gently pulling it straight out and twisting it. No luck either way doing it gently. I will try harder when I know how it goes.