Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No power to ignition switch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="lanceh55" data-source="post: 98172" data-attributes="member: 12460"><p>Tazza, thanks for the reply. Yes there is an LCD display on the left side. This Bobcat has standard controls, foot pedals for tilt and raising the bucket. I did swap a couple of the relays around but no help, Switch Power, Glow Plugs, and Starter. The term the Bobcat Service Manual uses is a Controller rather than a computer. I assume the Controller is a computer. The controller is located in the lower left front of the cap behind a plate near your left foot. It has two wire looms with lots of wires. I removed one of the wire loom plugs and the pins on the Controller looked good. (The wire schematic shows 50 pins per plug.) There is a light coating of grease around the pins and at the end of the plug. Every thing looked good clean. The plugs are held in with a bolt. I also removed the plug coming from the ignition switch (3 wires, red, white and I think yellow) that goes into the instrument panel. There was no power at the instrument panel, the red wire should be hot to energize the system from the ignition key. My next investigation will checking the wires from the right control panel.</p></blockquote><p></p>
[QUOTE="lanceh55, post: 98172, member: 12460"] Tazza, thanks for the reply. Yes there is an LCD display on the left side. This Bobcat has standard controls, foot pedals for tilt and raising the bucket. I did swap a couple of the relays around but no help, Switch Power, Glow Plugs, and Starter. The term the Bobcat Service Manual uses is a Controller rather than a computer. I assume the Controller is a computer. The controller is located in the lower left front of the cap behind a plate near your left foot. It has two wire looms with lots of wires. I removed one of the wire loom plugs and the pins on the Controller looked good. (The wire schematic shows 50 pins per plug.) There is a light coating of grease around the pins and at the end of the plug. Every thing looked good clean. The plugs are held in with a bolt. I also removed the plug coming from the ignition switch (3 wires, red, white and I think yellow) that goes into the instrument panel. There was no power at the instrument panel, the red wire should be hot to energize the system from the ignition key. My next investigation will checking the wires from the right control panel. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No power to ignition switch
Top