Reply to thread

Message: <blockquote data-quote="Hondaman900" data-source="post: 7952" data-attributes="member: 568">My operating levers are "snatchy", especially on the right side. I have to pull back hard to get full engagement of reverse with the right hand drive, and then the lever/clutch "sticks" rather than returns to the central neutral position. I have to push it forward a little and it releases. This can cause some jerky movement, and when working on a slope, has led to some hairy moments.I've adjusted the clutches, and can adjust the amount of travel of the lever from neutral to engagement, but this adjustment doesn't change or help the sticking. Apart from this issue, by M-600 runs and operates like a champ. Just cleared a Bobcat-wide road down my hillside property through thick brush, just using my chainsaw to fell trees and nip bushes, and then follow with the Bobcat to clear the debris and grade the road. Piece of cake in two afternoons, and a lot of fun.Any ideas/suggestions on the sticky levers? I'd love to smooth out the operation.Stephen</blockquote>