Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
New member with 1995 853
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="FJRDarksider" data-source="post: 132989" data-attributes="member: 22866"><p>I have a 1993 853. It had a few electrical issues which have been sorted, along with worn out pins/bushings etc. Mine came with a fuel pump as well but it runs just fine with it so not sure when it was installed. Changed oil and filters, a few hoses, and rebuilt the tilt cylinder.....learning as I go LOL. Not sure about your hydraulic light if the fluid level is good.....perhaps a bad sensor or stuck solenoid? </p><p></p><p>I had a leak on the steering servos as well but other than being a bit awkward to get at, it really is fairly straight forward. Had to get the o-rings at Bobcat as I could not find one close enough with the right diameter and thickness....had a broken spring as well. There is a post somewhere on here walking you through the process, but the SM has good detail on it.</p><p></p><p>I degreased mine with simple green and careful use of a pressure sprayer without issue.</p><p></p><p>Enjoy!</p></blockquote><p></p>
[QUOTE="FJRDarksider, post: 132989, member: 22866"] I have a 1993 853. It had a few electrical issues which have been sorted, along with worn out pins/bushings etc. Mine came with a fuel pump as well but it runs just fine with it so not sure when it was installed. Changed oil and filters, a few hoses, and rebuilt the tilt cylinder.....learning as I go LOL. Not sure about your hydraulic light if the fluid level is good.....perhaps a bad sensor or stuck solenoid? I had a leak on the steering servos as well but other than being a bit awkward to get at, it really is fairly straight forward. Had to get the o-rings at Bobcat as I could not find one close enough with the right diameter and thickness....had a broken spring as well. There is a post somewhere on here walking you through the process, but the SM has good detail on it. I degreased mine with simple green and careful use of a pressure sprayer without issue. Enjoy! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
New member with 1995 853
Top