Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
My Bobcat 751 with Peugeot Engine Timing belt and water pump swap
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="shawn macananny" data-source="post: 70717" data-attributes="member: 7155"><p>Well it stopped raining out so i decided to go check it out tonight. I unhooked fan belt, still made the noise, unhooked the alternator, still made the noise. I dissembled it all and removed the timing belt, all idlers are fine, spin freely and no play, water pump spins freely maybe a tiny tiny bit if play but i would cal it normal. No grinding or anything when pulling sideways on it with a good amount of pressure and spinning it</p><p>the worst part is a tapped the crank pulley to remove it, because it was stuck, and i actually broke it, i tapped it with a rubber mallet too, not even a plastic or dead blow hammer. I gotta go try to find one of those now, i cant believe i broke that. It wouldnt budge i ended up heating it up gradually with a torch and banging it around with the rubber mallet and some pb blaster until it came free.</p></blockquote><p></p>
[QUOTE="shawn macananny, post: 70717, member: 7155"] Well it stopped raining out so i decided to go check it out tonight. I unhooked fan belt, still made the noise, unhooked the alternator, still made the noise. I dissembled it all and removed the timing belt, all idlers are fine, spin freely and no play, water pump spins freely maybe a tiny tiny bit if play but i would cal it normal. No grinding or anything when pulling sideways on it with a good amount of pressure and spinning it the worst part is a tapped the crank pulley to remove it, because it was stuck, and i actually broke it, i tapped it with a rubber mallet too, not even a plastic or dead blow hammer. I gotta go try to find one of those now, i cant believe i broke that. It wouldnt budge i ended up heating it up gradually with a torch and banging it around with the rubber mallet and some pb blaster until it came free. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
My Bobcat 751 with Peugeot Engine Timing belt and water pump swap
Top