Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Other Brand Skidsteer Forums
Mustang Skidsteer Forum
Mustang 345 No Spark
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jim6346" data-source="post: 89431" data-attributes="member: 12899"><p>Hi Everyone!! Just picked up an older Mustang 345 Skid Steer. It turns over fine but is not getting any spark. I have replaced the Plugs, Coil, Cap, Rotor, Points, and Condenser. Verified the gap on the points is .025 (per the manual) and the plugs are .032. I have 12V on the + side of the coil with the ignition on. I have 12V on one side on the resistor and ~5V on the other side. I have ~5V on one side of the points and verified the other side is tied to ground. The points are opening and closing, but I don't see any spark at all. I am stumped, hoping someone on here might have some ideas? Thanks,, Jim</p></blockquote><p></p>
[QUOTE="jim6346, post: 89431, member: 12899"] Hi Everyone!! Just picked up an older Mustang 345 Skid Steer. It turns over fine but is not getting any spark. I have replaced the Plugs, Coil, Cap, Rotor, Points, and Condenser. Verified the gap on the points is .025 (per the manual) and the plugs are .032. I have 12V on the + side of the coil with the ignition on. I have 12V on one side on the resistor and ~5V on the other side. I have ~5V on one side of the points and verified the other side is tied to ground. The points are opening and closing, but I don't see any spark at all. I am stumped, hoping someone on here might have some ideas? Thanks,, Jim [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Mustang Skidsteer Forum
Mustang 345 No Spark
Top
