Mustang 2040 - starts but stalls after 3 seconds

[paulroyans]

Hello, My Mustang 2040 skid steer starts but stalls after 3 seconds. I have tried bypassing the fuel cut off relay which works but locks out the hydraulics. So i have eliminated that. The seat and seatbelt switches were bypassed when i bought the machine so that has also been eliminated.I replaced the charge pressure switch. I am not sure what else can cause the engine to cut out? Any ideas? Thank you

 

[fork8000]

https://www.youtube.com/watch?v=BJ34yPF2Pzw fuel filter/air in fuel sys? engine fluid levels? (murphy type systems)

 

[farmshop]

https://www.youtube.com/watch?v=BJ34yPF2Pzw fuel filter/air in fuel sys? engine fluid levels? (murphy type systems)

Not sure what your machine has for electronics but our 2044 and 2054 have a timer module in the front dash that can go bad and cause grief. There is also a main controller in the cab on the left side.

 

[drg25]

https://www.youtube.com/watch?v=BJ34yPF2Pzw fuel filter/air in fuel sys? engine fluid levels? (murphy type systems)

I have a 2008 model 2054 . last week it started & ran for 4hrs I shut it off ,tried to start again and it would start and stop right away. if anyone can help I would appreciate it

 

[drg25]

I have a 2008 model 2054 . last week it started & ran for 4hrs I shut it off ,tried to start again and it would start and stop right away. if anyone can help I would appreciate it

is it possible for me to get in contact with farmshop my email is [email protected]? Thank you

 

[farmshop]

is it possible for me to get in contact with farmshop my email is [email protected]? Thank you

I replied to your thread