Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Other Brand Skidsteer Forums
Mustang Skidsteer Forum
Mustang 1200a , Problem with variable drive , drive pulley
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Rick.Gerek" data-source="post: 91565" data-attributes="member: 13188"><p>I have rebuilt the motor and all was great until the variable drive pulley stopped working . I removed it and though I do see some wear , I did not see anything wrong. I have ordered a rebuild kit but before I remove it I was wondering if anyone knew how much pressure I should have at the pulley. I have purchased a OM and a parts manual but I can not find a service manual anywhere. My lifting seems a little slow but ok. Also I crossed referenced the rebuilt kit and it seems it was also used on a John Deere 170 skid steer. I have found a service manual for the John Deere 170 buts it's another $65 and I am not sure they are enough alike. Anyone have some knowledge or suggestions.</p></blockquote><p></p>
[QUOTE="Rick.Gerek, post: 91565, member: 13188"] I have rebuilt the motor and all was great until the variable drive pulley stopped working . I removed it and though I do see some wear , I did not see anything wrong. I have ordered a rebuild kit but before I remove it I was wondering if anyone knew how much pressure I should have at the pulley. I have purchased a OM and a parts manual but I can not find a service manual anywhere. My lifting seems a little slow but ok. Also I crossed referenced the rebuilt kit and it seems it was also used on a John Deere 170 skid steer. I have found a service manual for the John Deere 170 buts it's another $65 and I am not sure they are enough alike. Anyone have some knowledge or suggestions. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Mustang Skidsteer Forum
Mustang 1200a , Problem with variable drive , drive pulley
Top
