M600 right side doesn't have power

[spermicide]

I have a Melroe M600 skid steer. I just replaced the drive belt and after about 10 mins of using it the right side cut out. The left side still works as should. Right side wont go forward or reverse. Where should I start with troubleshooting the problem?

 

[flyerdan]

Chances are the clutches are out of adjustment or worn down on that side. Although it's rare for both fwd and rev to go, usually one direction is affected first.
There is a very active Melroe owners facebook group that deals with these clutch machines, you should check them out, they've probably got the solution documented somewhere.

 

[spermicide]

Chances are the clutches are out of adjustment or worn down on that side. Although it's rare for both fwd and rev to go, usually one direction is affected first.
There is a very active Melroe owners facebook group that deals with these clutch machines, you should check them out, they've probably got the solution documented somewhere.

Thank you very much. Ill be sure to check it out and post back here how it goes.

 

[spermicide]

Thank you very much. Ill be sure to check it out and post back here how it goes.

turns out it was just my drive chain fell off. so I put it back on and runs great! Thank you for your input.