Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
LX885 blowing hydraulic oil out of engine to transmission gearbox
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="tech.35058" data-source="post: 133325" data-attributes="member: 14347"><p>one other thing, these new seals with the rubber like coating on the outer outer rim.</p><p>you are supposed to lubricate the out side & just push them in. When they first came out, I destroyed a bunch of them before I caught on about lubricating them.</p><p> On my skidsteer pump, I used a piece of pipe that would go over the shaft, but not sit on the delicate part of the seal ( lip) yet still had room to install the snap ring. I would say I used an "H" bar( or a board or something) and a couple of pieces of all-thread in the mounting slots to push the seal in & hold it while I installed the snap ring .</p></blockquote><p></p>
[QUOTE="tech.35058, post: 133325, member: 14347"] one other thing, these new seals with the rubber like coating on the outer outer rim. you are supposed to lubricate the out side & just push them in. When they first came out, I destroyed a bunch of them before I caught on about lubricating them. On my skidsteer pump, I used a piece of pipe that would go over the shaft, but not sit on the delicate part of the seal ( lip) yet still had room to install the snap ring. I would say I used an "H" bar( or a board or something) and a couple of pieces of all-thread in the mounting slots to push the seal in & hold it while I installed the snap ring . [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
LX885 blowing hydraulic oil out of engine to transmission gearbox
Top