LX865 run mode issue

[jesnic]

I have the machine running after it sat for many years. It will start and run in service mode. In run mode, the seat belt light and park brake light stay flashing

 

[deaop06]

jesnic, Don't know about your machine but the lights should go out when you fasten the seat belt. Looks like you have 2 seat sensors and a seat belt safety switch. I have an L555 with the same setup. When you set in seat the belt light comes on. I don't have a brake switch. You may already know all this. Make sure all the switches are working. They control the boom and bucket hydraulics also. Good luck

 

[Mike10]

With the key off and service run switch in run position, sit in seat while watching panel. All the lights will light up if the seat circuit is OK. After the self check only the seat belt and park brake light will remain on. Fastening the seat belt will put out the seat belt light if that circuit is good. The seat belt buckle has has a switch that is probably bad which requires the seat belt ass be replaced.