Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
Lx565 hydraulics tilt bucket problem - Manual service LX565 L565 LX665 inside
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Shanmar" data-source="post: 134660" data-attributes="member: 21969"><p>There is another thread about an LS180 having the same type of problems. In that case, they already checked everything I mentioned to you above. Here is what I suggested next for them. It may be the next step for you:</p><p></p><p>"Given all of that, one would have to believe it is sending oil to the cylinders. Can you notice the hoses move some (flex) when you try to tilt the bucket? You could disconnect a hose and see if oil flies when you move the valve. Just make sure you think through all the safety issues there. Finally, if there's oil getting to the cylinders then the seals on one of the pistons inside of the cylinders must be bad leaving oil by. New Holland does sell a rebuild kit. If you have a big pipe wrench and a serious impact gun I can tell you how we went about rebuilding ours. For us, the seal where the rod comes out of the cylinder would usually fail. Very seldom did the piston seals cause us issues, but that could be a difference in how the machines are used."</p></blockquote><p></p>
[QUOTE="Shanmar, post: 134660, member: 21969"] There is another thread about an LS180 having the same type of problems. In that case, they already checked everything I mentioned to you above. Here is what I suggested next for them. It may be the next step for you: "Given all of that, one would have to believe it is sending oil to the cylinders. Can you notice the hoses move some (flex) when you try to tilt the bucket? You could disconnect a hose and see if oil flies when you move the valve. Just make sure you think through all the safety issues there. Finally, if there's oil getting to the cylinders then the seals on one of the pistons inside of the cylinders must be bad leaving oil by. New Holland does sell a rebuild kit. If you have a big pipe wrench and a serious impact gun I can tell you how we went about rebuilding ours. For us, the seal where the rod comes out of the cylinder would usually fail. Very seldom did the piston seals cause us issues, but that could be a difference in how the machines are used." [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
Lx565 hydraulics tilt bucket problem - Manual service LX565 L565 LX665 inside
Top