Reply to thread

Message: <blockquote data-quote="dondiesel444" data-source="post: 73622" data-attributes="member: 10499"><p>thanks, I was able to get the old one out, dropped the bottom plate, and used a tie-rod "pickle-fork" to apply outward pressure while spinning the bolt out with an impact gun. there were no threads at all on the bolt, and there are hardly any in the pan. I picked up a 3/4"-16 single oversize plug at napa for $3, came with a new gasket also. It's a touch bigger than the old one, and tapered so it should cut new threads when installing it for the first time. I am gonna put it in there tomorrow, hopefully it will seal and not leak....</p></blockquote><p></p>