Reply to thread

Message: <blockquote data-quote="Ice Cold" data-source="post: 70194" data-attributes="member: 5354"><p>to clarify, the uneven wear marks are on the non-tapered part of the pin, the bobtach side. ... they seem to seat very well but for some reason the seal was pulled through and mashed. Maybe when I was torquing it but perhaps due to crooked seating of pin it worked itself out during the hour of use and was mashed due to developing slop (minor on my machine) on the lower end. .... what about this....... install pins without bobtach, hammer them in, torque bolts, re-hammer, re-torque and lay a straight edge between them to see if aligned. .... I'll call the dealer tomorrow too and check back in. Thanks</p></blockquote><p></p>