Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="heatpumpproducts" data-source="post: 13024" data-attributes="member: 1332"><p>i just ordered my manual (operation) for my L565. but i still have a few questions on what do the sensors do , now the hydrolic temp -reads temp of the fluid in the return tank of the hydro and but wear does it get its power from , the hydrolic presure sensor is located at the hydrolic filtertowards the out side fender, but where does it get its power from , and when can it be activated when the service switch is on or only in the run and ignition cycle . the third switch is called a restrictor located on the other side of the hydrolic filter ,What does it do. again how would i test it . i some times have probles with the seat belt making good contact and this seams to lock out the arms and bucket , i have other post about that .( i read on a post that that there is a service bulleton on this problem .were do i find out about these BULLETON'S and would the dealer still have to warrenty it . or are they just going to explane a way to fix it. i also have a problem with the bucket rotating slowly forward away from the cab when in motion full or empty ,but it still has lots of power to break out hard ice and snow . the messick parts site shows the hydro checks for the bucket but where is it located on the machine . now what if anything can i do to check for falt or problems with it .is there any electrical conections on its that could be the problem and could all of these be related some how . i will check all grounds today that i can find and repost .</p></blockquote><p></p>

Verification