Reply to thread

Message: <blockquote data-quote="heatpumpproducts" data-source="post: 12916" data-attributes="member: 1332"><p>1.i have just finished to install my heater , and when i started the machine a new light was flashing , the top left corner it has a tear drop in a gear and a bar under it , now at the same time on the right side the tear drop in a gear light was flashing , and for the first time the hydrolic temp had a reading of 250 degress cel before this it only read cold , now i ran it hard last week end for snow storm clean up for 5 hrs and 3.5 hrs again the next day but it read only cold WHAT'S up. the fluid is at a good level and does not seem to be dropping at all my other question is where is the sensor for the hydrolic system and if it reads is it bad ,can it be calibrated .could you email me an explanation of the different lights . 2.i still have a little fad in the bucket , starting to be a pain in the but .is thier anything you mite suggest on whats the cause is .(the bucket falls forward slowly ,when put in the forthest most up right position towards the cab .)email ;kiermizuik@rogers.com thanks from n.b.can.</p></blockquote><p></p>