Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
kubota/timing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 48959" data-attributes="member: 82"><p>The marks should only ever line up in one place. You will have one large one (idle gear) with three sets of markings. Position it so it points to all three gears then line them up to the respective points.</p><p>The large gear should have 3 sets of dots, each gear its to mesh with should have the same dots as the large one. There will be 1 dot then two then three.</p><p>I have a PDF manual, i just checked and it says there should be markings</p></blockquote><p></p>
[QUOTE="Tazza, post: 48959, member: 82"] The marks should only ever line up in one place. You will have one large one (idle gear) with three sets of markings. Position it so it points to all three gears then line them up to the respective points. The large gear should have 3 sets of dots, each gear its to mesh with should have the same dots as the large one. There will be 1 dot then two then three. I have a PDF manual, i just checked and it says there should be markings [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
kubota/timing
Top