Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
JD circuit board interchangeable with NH?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Morel1" data-source="post: 62191" data-attributes="member: 8288"><p>I had this problem too, check the fuse block inside the cab next to the run/service switch. It's the one labeled NOT FUEL, second 5 amp from the back. After spending time at the JD dealership and looking at an orginial service manual I found out that this circuit is a voltage signal to the board and if it does not have it it will shut off the engine in 1 second. The only troubleshooting answer for this condition. You might have a short, checking the wiring harness is easy, the board is harder to pin point. Go to a JD dealership and ask for bulletin 95-11-55-31 it might help you.</p></blockquote><p></p>
[QUOTE="Morel1, post: 62191, member: 8288"] I had this problem too, check the fuse block inside the cab next to the run/service switch. It's the one labeled NOT FUEL, second 5 amp from the back. After spending time at the JD dealership and looking at an orginial service manual I found out that this circuit is a voltage signal to the board and if it does not have it it will shut off the engine in 1 second. The only troubleshooting answer for this condition. You might have a short, checking the wiring harness is easy, the board is harder to pin point. Go to a JD dealership and ask for bulletin 95-11-55-31 it might help you. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
JD circuit board interchangeable with NH?
Top
