Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="sph606" data-source="post: 73227" data-attributes="member: 10428"><p>I first talked to the dealer who said to start by replacing the park brake solenoid. I did that and still got the same code. The solenoid cost $87.00. Then I pulled the solenoid switch attached the old solenoid to it and jumped a wire from the battery to test it. The switch functioned as it should with the jumper wire to it. Then I put a test light from the positive side of the battery to one of the two wires feeding the solenoid. The black wire light up so I assume this is the negative wire. Then I switched the test light to the negative side of the battery and touched it to the blue wire and got nothing. Then I turned the ignition switch on & nothing. I tried to put the park brake switch in different positions and still nothing. At this point I am certain that I have no current going to the park brake solenoid. So then I went to the menu and opened the diag, then went to park brake. When I toggled the park brake switch the diag would show it to be open or closed. This indicated to me that the park brake was functioning properly. At this point I have cleaned every wire that was under a nut and taken every plug connection apart and re-connected it. Not having much experience with this sort of problem the only thing I could think to do is replace the park brake switch. The switch cost $42.00 and that was not the problem. Any suggestions on where to go from here ?</p></blockquote><p></p>

Verification