Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
JD 260 won't start.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Ken the Mender" data-source="post: 127639" data-attributes="member: 17499"><p>Have a JD 260 diesel skid steer that was working fine, then it died while running and now if the key is turned to run or start position nothing happens. Volt gauge doesn't register voltage when key is turned on. Checked battery-12 volts. connections good. 12 volts at positive starter terminal. Tried remote starter switch, but mine is a piece of crap. Checked voltage at intake heater relay-12 volts. Pulled the overhead dash panel and back probed the ignition switch. No voltage at the switch connection. Fuse panel under the cab has 12 volts. Safety switches under seat and for the belt were bypassed. </p><p>The driver said that when it died at first he slammed the roll up cab door and the skid steer started up. </p><p></p><p>My question is-are there any places where wiring corrodes (used to load salt in winter) or brakes in wiring from cab being raised.</p></blockquote><p></p>
[QUOTE="Ken the Mender, post: 127639, member: 17499"] Have a JD 260 diesel skid steer that was working fine, then it died while running and now if the key is turned to run or start position nothing happens. Volt gauge doesn't register voltage when key is turned on. Checked battery-12 volts. connections good. 12 volts at positive starter terminal. Tried remote starter switch, but mine is a piece of crap. Checked voltage at intake heater relay-12 volts. Pulled the overhead dash panel and back probed the ignition switch. No voltage at the switch connection. Fuse panel under the cab has 12 volts. Safety switches under seat and for the belt were bypassed. The driver said that when it died at first he slammed the roll up cab door and the skid steer started up. My question is-are there any places where wiring corrodes (used to load salt in winter) or brakes in wiring from cab being raised. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
JD 260 won't start.
Top
