Reply to thread

Message: <blockquote data-quote="foton" data-source="post: 127217" data-attributes="member: 16041"><p>if there is only one hot wire going to the sensor then the sensor is the last thing on the circuit ,so yes just replace the sensor and you should be good to go. If there is two wires you need to take a look with a meter at the sensor and if both pins are at 0 or really ,really close to 0 ohms ,I would say it is bad. One would be a ground so it should read 0 ohms. hpoefully this will help.</p></blockquote><p></p>