Reply to thread

Message: <blockquote data-quote="coyote556" data-source="post: 112567" data-attributes="member: 7844"><p>Guys - Having float issues also, on Takeuchi TL230 Series 2. I posted another thread on it over on heavyequipmentforms.com (https://www.heavyequipmentforums.com/threads/tl230-series-2-float-diagnosis.83826/#post-901828). I am getting 12v from the button, to the controller, but no 12v out of the controller to the float solenoid. Does anyone know what the parameters are for the controller sending 12v to the float solenoid? That is no where in the service manual. I did a good job of laying out which pins go to the button and the solenoid, so I was able to check the wires and make sure they were good. I was also able to locate the output pin on the controller that feeds the float solenoid, but no current coming out when pushing the float button. I wish there was a "if this, then that" layout for the magic inside the controller. ideas??</p></blockquote><p></p>