Reply to thread

Message: <blockquote data-quote="Kudagra" data-source="post: 3997" data-attributes="member: 609"><p>773s use a rubber grommit and steel plug under the machine. If you lay down in the back and look where the flat area slopes up there should be a plate with 3 bolts in it. Pull that off and dig out all the mud. There will be 2 holes. Towards the FRONT is the chain case plug. Wipe it off. If its leaking go get a new grommit and plug (its cheap). Grease up the rubber part. THEN yank the old one out (Rubber and all), stick your finger over the hole. INstall the NEW rubber. Stick your finger over the hole. Quickly put the plug in the rubber hole. Hammer it in. Done without making TOO much mess. If you look towards the BACK of the machine you will see the SAME looking plug and grommit but in a plastic thing. That is the fuel tank. Dont poke a hole. If you pull out the 3/4" pipe plug in the FRONT OF THE MACHINE and oil comes out and your hyd tank is low....you probably have carrier seals out...DOH.</p></blockquote><p></p>