Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 3658" data-attributes="member: 82">I found the problem.....I had to chop out what was left of the mounting point wherre the ram meets the bobtach and weld a new one in, as the old one was so worn, i was sure i lined it all up before welding it in. It seems i was a little off, by a little i mean ALOT.I put a piece of 1 1/4 bar through the bosses and measured about 30cm out from it. At that distance i'm out by around 10 mm!!!! from side to side, and about 3mm from top to bottom..... this is something i really didn't need...... I swear i checked this before i welded it in.So... i'm going to have to chop out the mounting brackets i welded in and make a new set of the rotten things. I could get away with it if i just increase the clearance of the bushing but i think thats the wrong way to go about it, i'm going to have to get it rite and it should fix my problem once and for all.This is really not a job i need, i have enough jobs to do as it is without having to fix something i stuffed up. Hopefully i can cut them out neat enough to be able to weld them back in.</blockquote>