Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydrostatic fluid change/purge
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 29281" data-attributes="member: 307"><p>Bobbie</p><p>I forgot about the safety valve, but try that. After you lower the arms, start the engine and hit the boom down pedal. If the cyliders are empty it should take a couple seconds for the relief valve to start squealing while the pump filles the cylinder back up. If it squeals instantly you know it was able to suck oil back in. If thats the case remove the down pressure side of the cylinder hose and cap it off before you pull the red safety valve.</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 29281, member: 307"] Bobbie I forgot about the safety valve, but try that. After you lower the arms, start the engine and hit the boom down pedal. If the cyliders are empty it should take a couple seconds for the relief valve to start squealing while the pump filles the cylinder back up. If it squeals instantly you know it was able to suck oil back in. If thats the case remove the down pressure side of the cylinder hose and cap it off before you pull the red safety valve. Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydrostatic fluid change/purge
Top