Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydro pump noise 632 bobcat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 15937" data-attributes="member: 931"><p>Tazza, I replaced the bronze filter last year so I just cleaned it this time, there was a couple of small black flecks on it but that was all. Noise is less at higher rpm. I have run it about 1/2 hour total. I put a hose on the upper aux coupler and ran out a couple of quarts of oil and it did have fine bubbles in it. I also bought a 3000 psi gauge today and connected it dead head on the upper aux fitting and held the stick over to detent. The relief valve opened and the engine labored but the gauge did not move. I assume the gauge is no good. The I connected a return line filter in the line from the backhoe to the lower aux fitting and ran out a quart of oil to clean the line, connected it up and oil was circulating fine through the backhoe till I tried to raise the boom and blew the seal on the filter. How come? I still have not figured that out.</p></blockquote><p></p>
[QUOTE="jerry, post: 15937, member: 931"] Tazza, I replaced the bronze filter last year so I just cleaned it this time, there was a couple of small black flecks on it but that was all. Noise is less at higher rpm. I have run it about 1/2 hour total. I put a hose on the upper aux coupler and ran out a couple of quarts of oil and it did have fine bubbles in it. I also bought a 3000 psi gauge today and connected it dead head on the upper aux fitting and held the stick over to detent. The relief valve opened and the engine labored but the gauge did not move. I assume the gauge is no good. The I connected a return line filter in the line from the backhoe to the lower aux fitting and ran out a quart of oil to clean the line, connected it up and oil was circulating fine through the backhoe till I tried to raise the boom and blew the seal on the filter. How come? I still have not figured that out. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydro pump noise 632 bobcat
Top