Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic pressure warning 742B
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="wings5j" data-source="post: 40427" data-attributes="member: 1341"><p>Here's the latest,</p><p>I confirmed the pressure differential sensor on the filter housing was bad and had Bobcat send me a new one and will put this on when I get home.</p><p>I decided I should check out the other two sensors while I was at it. My wiring diagram does not show the sensors. When I lift the cab I can see the pre-charge sensor on top of the hdrostat. It has two wires connected to two seperate terminals (Are these supposed to be "normally closed" between them?) and I am not sure of the basics on this one.</p><p>As to the temp sensor on the port block, I have not located it yet.</p><p>I am surprised that my factory service manual does not include this system in the wiring diagrams. I would appreciate any more advice you might have.</p><p>Thanks,</p><p>John</p></blockquote><p></p>
[QUOTE="wings5j, post: 40427, member: 1341"] Here's the latest, I confirmed the pressure differential sensor on the filter housing was bad and had Bobcat send me a new one and will put this on when I get home. I decided I should check out the other two sensors while I was at it. My wiring diagram does not show the sensors. When I lift the cab I can see the pre-charge sensor on top of the hdrostat. It has two wires connected to two seperate terminals (Are these supposed to be “normally closed” between them?) and I am not sure of the basics on this one. As to the temp sensor on the port block, I have not located it yet. I am surprised that my factory service manual does not include this system in the wiring diagrams. I would appreciate any more advice you might have. Thanks, John [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic pressure warning 742B
Top
