hydraulic oil pressure switch

[bobcat743b]

my hydraulic oil pressure light comes on when I start it. found the switch on side of the hydraulic oil cannister. can someone tell me the part number for the switch, cannister has a number of 6598903 for it. don't know if that's correct or not. I have found the parts manual on bobcat but it wont list the parts number, this is a 743B Late model bobcat skid steer thanks

 

[Tazza]

I doubt that is the switch that is your issue, normally it's the one under the cab screwed into the port block. The one at the oil filter is for over pressure by-pass, used for when the oil filter is plugged up.
If you lift the cab, look at the ump and the fat hose going to the left side, there will be two pressure switches here from meory. The brass one is temperature, the other is the pressure.

 

[bobcat743b]

I doubt that is the switch that is your issue, normally it's the one under the cab screwed into the port block. The one at the oil filter is for over pressure by-pass, used for when the oil filter is plugged up.
If you lift the cab, look at the ump and the fat hose going to the left side, there will be two pressure switches here from meory. The brass one is temperature, the other is the pressure.

I think your right. I found a switch number 6671062. anyone know if that's the right part number. thanks

 

[Tazza]

I think your right. I found a switch number 6671062. anyone know if that's the right part number. thanks

Can't tell you for sure, but looking up that number on the googles, it looks like the exact switch that i thought it was.