Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic Drive Motor....Backwards?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Jeffscarstrucks" data-source="post: 17292" data-attributes="member: 1245"><p>It is always an adventure learning all of different intricate mechanicals when working on all kinds of machines. Taz, Do you think that one could retime the motor by moving the center plate in the input (fluid) section by going through the 'A' port with a tool and moving the plate about two thirds of the way between two feed holes on the plate? (is that clear....). I am assuming that if it runs backwards that this would be the fix, To redirect fluid flow per given input. I am trying to figure this out on the fly as I don't seem to find anything on the net. It seems that this Danfoss motor uses an Eaton final drive (similar to Case) with two tapered bearings that oppose each other like car wheel bearings. Thanks, JEFF</p></blockquote><p></p>
[QUOTE="Jeffscarstrucks, post: 17292, member: 1245"] It is always an adventure learning all of different intricate mechanicals when working on all kinds of machines. Taz, Do you think that one could retime the motor by moving the center plate in the input (fluid) section by going through the 'A' port with a tool and moving the plate about two thirds of the way between two feed holes on the plate? (is that clear....). I am assuming that if it runs backwards that this would be the fix, To redirect fluid flow per given input. I am trying to figure this out on the fly as I don't seem to find anything on the net. It seems that this Danfoss motor uses an Eaton final drive (similar to Case) with two tapered bearings that oppose each other like car wheel bearings. Thanks, JEFF [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic Drive Motor....Backwards?
Top