Reply to thread

Message: <blockquote data-quote="Jeffscarstrucks" data-source="post: 17208" data-attributes="member: 1245"><p>I removed the track drive motor from my machine to replace the output shaft bearings. I seperated the two motor segments from the output segment and did not disturb a thing on the motor sections. The bearing replacement went fine along with a new seal and O-rings and the motor went back together fine. Today was the big install (part of a bigger undercarriage rebuild) and the lovely thing ran backwards!(opposite of control input). It is a Danfoss 400 motor that runs the track drive. I have posted this here because I know that nearly all of the folks on this forum read this section and have helped me with Bobcat isues before. I have only guessed at possible problems and the hoses are on as before. It never fails that it would happen on a Friday evening! Thanks in advance, Jeff</p></blockquote><p></p>