Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydr drive motor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Sx200" data-source="post: 3280" data-attributes="member: 198"><p>thanks tazza, all the seals were available at a local seal and bearing place, 'allied seals and bearings', got high temp ones and it came to $15 for the lot.... about $150 from bobcat Australia????? i think it was just an o ring? or maybe a backup ring? no seal as such which suprised me. so it couldnt have been too hard or expensive....(id remember that lol) pulling the motor out was a painful filthy job, then gettiing the sprocket nut and sprocket off were the hardest bit. ended up getting some plumbers stilsens!! for the small nuts on the other side u need a quality 7/16 (i think) cos the holes are tight and not 6 sided.....taking the motor apart isnt that hard once its off, the timing was a bit of a bitch, couldnt work it out first time lol.................................................................................................................................................................................................................................................... as for mine sorted out air problem but didnt fix it. i just think it must have some crap lodged in somewhere. ill keep bleeding poppet and see if it clears up. asked gold coast bobcat and even though they were helpfull admitted to knowing nothin about hydraulics? which astounded me lol!!! theres a couple of other people on the coast but i got robbed over grand with the first one so am not willing to try his mate! if all else fails ill take it off (again) and have another look inside.</p></blockquote><p></p>
[QUOTE="Sx200, post: 3280, member: 198"] thanks tazza, all the seals were available at a local seal and bearing place, 'allied seals and bearings', got high temp ones and it came to $15 for the lot.... about $150 from bobcat Australia????? i think it was just an o ring? or maybe a backup ring? no seal as such which suprised me. so it couldnt have been too hard or expensive....(id remember that lol) pulling the motor out was a painful filthy job, then gettiing the sprocket nut and sprocket off were the hardest bit. ended up getting some plumbers stilsens!! for the small nuts on the other side u need a quality 7/16 (i think) cos the holes are tight and not 6 sided.....taking the motor apart isnt that hard once its off, the timing was a bit of a bitch, couldnt work it out first time lol.................................................................................................................................................................................................................................................... as for mine sorted out air problem but didnt fix it. i just think it must have some crap lodged in somewhere. ill keep bleeding poppet and see if it clears up. asked gold coast bobcat and even though they were helpfull admitted to knowing nothin about hydraulics? which astounded me lol!!! theres a couple of other people on the coast but i got robbed over grand with the first one so am not willing to try his mate! if all else fails ill take it off (again) and have another look inside. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydr drive motor
Top