Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
General Skidsteer & Technical Topics
Shop Talk
Hoof governor rebuild parts
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Cyclone Ranger" data-source="post: 49983" data-attributes="member: 6638"><p>My Bobcat 642 uses a Hoof governor mdl BD 856 A. I'm in the process of replacing seals and bearings. Here is what I have so far that may be of help to others undergoing a similar endeavor. Bearing: Timken MM202K. Pulley: Grainger PN# 3X909m (will need to drill to 15mm ~ 19/32"). Still searching for seals and bushings. Here is what I have on them so far: Front seal: OD: 28.5mm. Shaft size: 15mm. Width: 8mm. Not yet sure how to handle the actuator seal. If anyone is out there who has experience rebuilding these governors I welcome input.</p></blockquote><p></p>
[QUOTE="Cyclone Ranger, post: 49983, member: 6638"] My Bobcat 642 uses a Hoof governor mdl BD 856 A. I'm in the process of replacing seals and bearings. Here is what I have so far that may be of help to others undergoing a similar endeavor. Bearing: Timken MM202K. Pulley: Grainger PN# 3X909m (will need to drill to 15mm ~ 19/32"). Still searching for seals and bushings. Here is what I have on them so far: Front seal: OD: 28.5mm. Shaft size: 15mm. Width: 8mm. Not yet sure how to handle the actuator seal. If anyone is out there who has experience rebuilding these governors I welcome input. [/QUOTE]
Verification
Post reply
Forums
General Skidsteer & Technical Topics
Shop Talk
Hoof governor rebuild parts
Top
