Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hi-Flow Conversion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="sam-tip" data-source="post: 62092" data-attributes="member: 8065"><p>I took plenty of pictures. Without pictures I would not have gotten it back together. Total cost was just over $4,000. Way cheaper than trading. My machine now has 520 hours. It would have been 32k to trade. Thanks EPA. I spent allot of time just reading the manuals and trying to figure how to get the parts back in without killing myself. I did have one leak. It was my fault. I wasn't positive if I got it tight. But it was easy to get tight. One of the few fittings I could still get to. It took so long because one of the hard lines was back ordered for a month. I just worked on it myself. Figured if it was just me I would remember where each part came from. I have had help before and we had parts that my friends removed and didn't remember where they went. Then there were parts I could not get loose. Had to take a over night break. With a fresh look at the part it suddenly became easy.</p></blockquote><p></p>
[QUOTE="sam-tip, post: 62092, member: 8065"] I took plenty of pictures. Without pictures I would not have gotten it back together. Total cost was just over $4,000. Way cheaper than trading. My machine now has 520 hours. It would have been 32k to trade. Thanks EPA. I spent allot of time just reading the manuals and trying to figure how to get the parts back in without killing myself. I did have one leak. It was my fault. I wasn't positive if I got it tight. But it was easy to get tight. One of the few fittings I could still get to. It took so long because one of the hard lines was back ordered for a month. I just worked on it myself. Figured if it was just me I would remember where each part came from. I have had help before and we had parts that my friends removed and didn't remember where they went. Then there were parts I could not get loose. Had to take a over night break. With a fresh look at the part it suddenly became easy. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hi-Flow Conversion
Top