Reply to thread

Message: <blockquote data-quote="shawn macananny" data-source="post: 59788" data-attributes="member: 7155"><p>I did clean both screens when i drained the case and i did replace both of the hydraulic filters. I filled the case with bobcat hydrostatic fluid instead of kubota, could this be causing an issue? The dealer said it wouldnt matter and i had an extra 5 gallons from my 751 so i just used it. There are a couple rubber hoses that look like they should be replaced, but i dont see any dampness at all around them and there are new lines running to the cooler. The spin on filters are both tight and i know the gasket surfaces were clean and orings not damaged when i installed them. i guess i will start by replacing the two small hose pieces, any reason i cant use heater hose for these hydraulic suction lines? they are really only about 3 inches long and joining two hard lines</p></blockquote><p></p>