Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Has anyone rebuilt a fan gearbox?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="KyMadMan" data-source="post: 102621" data-attributes="member: 2826"><p>Hi 7LBSSMALLIE, I've torn down the fan / blower gearbox on my 753 and it is obvious at least the bearings in the short housing need replacement. Also there seems to be the need for a couple more shims on one or both shafts. Before I get parts I want to check fitment of the bearings on the short housing. Are these bearings suppose to fit in the housing so tight as to need a press to remove and reinstall them or is it a snug fit on the tapered end side allowing them to be tapped out with a hammer and non-metal punch? I'm not sure if housing needs replacement or if I'm ok and good to go. I realize they need to be pressed on and off the shafts. The Service Manual states that the bearings may come out with the shaft but not sure what that actually means as far as needing a press to accomplish this. Thanks in advance for input suggestions etc. KMM</p></blockquote><p></p>
[QUOTE="KyMadMan, post: 102621, member: 2826"] Hi 7LBSSMALLIE, I've torn down the fan / blower gearbox on my 753 and it is obvious at least the bearings in the short housing need replacement. Also there seems to be the need for a couple more shims on one or both shafts. Before I get parts I want to check fitment of the bearings on the short housing. Are these bearings suppose to fit in the housing so tight as to need a press to remove and reinstall them or is it a snug fit on the tapered end side allowing them to be tapped out with a hammer and non-metal punch? I'm not sure if housing needs replacement or if I'm ok and good to go. I realize they need to be pressed on and off the shafts. The Service Manual states that the bearings may come out with the shaft but not sure what that actually means as far as needing a press to accomplish this. Thanks in advance for input suggestions etc. KMM [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Has anyone rebuilt a fan gearbox?
Top
