Reply to thread

Message: <blockquote data-quote="palfaro48" data-source="post: 124401" data-attributes="member: 22776"><p>Hey bud I have the same problem I empty out the tank disconnected the lines and blew them out replaced the water separator I put everything back and then it ran like it was new first turn of key boom on them I filled up the diesel tank half way when first turn it on I used a 5 gallon can so I knew it was clean diesel no water that code btw is for water detected in your lines I'm no expert either I'm an iron worker by trade doing the same as you mention so back to it I ran I then connected everything back made sure it was clean no dirt ect ect tafter putting everything back turned it on and everything is good right filled up the tank half way and everything still good this is about 10-15 min of running then decided to take it for a drive by 200 yards away from the house rPMs started going up and down then instead of getting the codes again the same one that said that it was water in the lines that 10 76–16 also that M0909, which is low fuel and also the 309 I think it is which is low battery. I haven't got far enough on your post. I don't know if you were able to fix the problem, I was just getting started with it.</p></blockquote><p></p>