Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Fuel injection timing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 5421" data-attributes="member: 82"><p>Ok, so i spent about 2 1/2 hrs today removing bits and pieces to gain access to the pump. Took it out and added 2 shims and re-checked timing. Put loctite on the shims and re-installed it again.</p><p>Gave me a little scare when it was starting. It started then just died, started again and refused to idle... it had be quite worried but after it purged all the air it ran just fine. I did bleed the tube lines before tightening them at the injectors to remove as much air as possible.</p><p>I will know in the next few days if it has fixed the problem or not, i just need to add a diode between the starter and glow solenoids so the 2 machines i have are essentially the same. I will then know if this has helped or not.</p><p>Thanks for the info on all this guys</p></blockquote><p></p>
[QUOTE="Tazza, post: 5421, member: 82"] Ok, so i spent about 2 1/2 hrs today removing bits and pieces to gain access to the pump. Took it out and added 2 shims and re-checked timing. Put loctite on the shims and re-installed it again. Gave me a little scare when it was starting. It started then just died, started again and refused to idle... it had be quite worried but after it purged all the air it ran just fine. I did bleed the tube lines before tightening them at the injectors to remove as much air as possible. I will know in the next few days if it has fixed the problem or not, i just need to add a diode between the starter and glow solenoids so the 2 machines i have are essentially the same. I will then know if this has helped or not. Thanks for the info on all this guys [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Fuel injection timing
Top
