Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 4103" data-attributes="member: 82">It wouldn't hurt trying to weld the hole on the block, its not like it will cost you much if you have the gear. You have little to loose.I take it that it has hung a rod? if the new con-rod isn't too expensive i would give it a go. Give the bore a quick rub with a flex hone or if you don't have one just some wet and dry sand paper.Make sure you give it a good clean out inside, i don't know if these run an oil pump or not but if it does clean it out as there will be metal particles floating around from when it punched the hole. I have a kubota engine that was full of small particles when it hung a rod.</blockquote>