Reply to thread

Message: <blockquote data-quote="USN Retired" data-source="post: 59317" data-attributes="member: 7040"><p>I am in the process of building an engine removal tool for my 753 using the diagram shown in the repair manual. I have all the parts cut out and ready to weld. Before I do the welding I want to drill and tap the holes for the two 3/8 X 1 1/4 inch bolts. I can see that the bolts are on centerline of the 1 inch thick plate. I believe the .3125" number is the drill bit size to use before tapping the holes for the 3/8" bolts. I am not sure what the .375" number is? Does it have anything to do with the distance the holes should be set in from the edge of the plate ? Any assistance is appreciated.</p></blockquote><p></p>