Does anyone know where to find the Diode on a 1993 440B?

[Gervs]

I'm trying to follow the wiring schematic in the manual. It says that there is a diode in the system. I found what looks like a battery tender type connector with a plug in it. I'll attach a picture. If that is it where do you buy a replacement? Also would like to add additional lights. Does anyone know where the original but optional light wiring harness was ran so it was safe from pinching when lifting the cab?

 

[Gervs]

Here is the picture of the connector.

 

[Tlawdogg]

Did you go to the Bobcat website and put your model and Serial number (P.I.N.)?
Click on Electrical. Click on harness picture.
Look at #27 in schematic..."Diode" .
Is that what you are looking for?
See attached screenshots.
Not sure on that connector...hopefully an expert will chime in. It looks like a battery tender or engine block heater..but just guessing.
Todd

Here is Bobcat link:https://partscatalog.bobcat.com/

 

[Gervs]

Did you go to the Bobcat website and put your model and Serial number (P.I.N.)?
Click on Electrical. Click on harness picture.
Look at #27 in schematic..."Diode" .
Is that what you are looking for?
See attached screenshots.
Not sure on that connector...hopefully an expert will chime in. It looks like a battery tender or engine block heater..but just guessing.
Todd

Here is Bobcat link:https://partscatalog.bobcat.com/

Thank you very much. The pic you posted of #27 actually looks like it might be it. I tried Bobcat website and all I get when I put in my model number was 6 parts. So I dug up my serial number and it is finally showing me everything. Thank you again! Any idea of where they ran the original Light circuit?

 

[Tlawdogg]

Sorry i do not know. I see a "Light kit" under your model.. does that look familiar?
Did your model come standard with lights?
There is also a back up alarm kit.

A shot in the dark: in the power/key panel. Might have a simple harness connect there.
Hopefully an expert on your model can confirm.
Todd

 

[Gervs]

No i am adding lights and want to run the wires in the original location for safety. Hoping that it will keep me from putting them somewhere that they get pinched or rubbed.

 

[Tlawdogg]

If you are putting lights off the front top (usual area to mount) I would run wiring onto key/panel . No pinching or a lot less rub. Are you adding rear lights too?

 

[Gervs]

Front and rear LEDs. There is no power to the cab right now. Everything is below the seat under cab. That's why i am hoping someone with a 440 can let me know where theirs are running. Thank you for all your help so far.