Reply to thread

Message: <blockquote data-quote="Mike10" data-source="post: 45128" data-attributes="member: 5461">That was the clamp I was talking about and the handle is the one you described.  To remove, take out the center panel between your legs which has eight 3/8" bolts, disconnect the aux handle rod which goes  to the control valve, remove the two springs, one on each side, from the neutralizing arms, remove the bolts that hold the bearings to the steering pods, on each side, for the neutrlizing cross shaft, lift the neutralizing cross shaft out.  disconnect the rod going to the hydro pump, find and disconnect the wiring connector, remove the five 3/8" bolts holding the pod to the frame, remove the pod and handle assy. The line should go out the side and I would replace both if they are severly corroded.</blockquote>