Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
deutz BF4M1011 tappet clearance
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Land-Tech" data-source="post: 24088" data-attributes="member: 1679"><p>These specs are right out of the manual.I checked to see about doing the fourth step but it is not mentioned.</p><p>As far as replacing the headbolts, I'm not sure. If I was doing it for someone else and Duetz required it, I would probably replace.Someone else on the site with more practical experience could tell us whether or not it's a common practice. On other heads that I have replaced, including an international 6.9, I used the original bolts without a problem.Scott</p></blockquote><p></p>
[QUOTE="Land-Tech, post: 24088, member: 1679"] These specs are right out of the manual.I checked to see about doing the fourth step but it is not mentioned. As far as replacing the headbolts, I'm not sure. If I was doing it for someone else and Duetz required it, I would probably replace.Someone else on the site with more practical experience could tell us whether or not it's a common practice. On other heads that I have replaced, including an international 6.9, I used the original bolts without a problem.Scott [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
deutz BF4M1011 tappet clearance
Top