Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
creaping 610
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 24202" data-attributes="member: 82"><p>I don't know what control valve you have but they will be behind plugs on either side of where the oil comes out of the valve. Some are parallel to the ports others are parallel with the spool. Check behind the plugs, there will be one for each high pressure outlet. They will have a spring and poppet but some have a body thats part of the plug with O rings, my old 731 had this style and the o-rings were shredded, i replaced them and it was perfect.</p><p>I would doubt they just run O rings in the cylinders, they will be propper seals on the piston, i can't guess what style though. The rods will use a propper pressure seal. If you pull the rams down, take it to a hydraulic seal shop and they can match them for you.</p></blockquote><p></p>
[QUOTE="Tazza, post: 24202, member: 82"] I don't know what control valve you have but they will be behind plugs on either side of where the oil comes out of the valve. Some are parallel to the ports others are parallel with the spool. Check behind the plugs, there will be one for each high pressure outlet. They will have a spring and poppet but some have a body thats part of the plug with O rings, my old 731 had this style and the o-rings were shredded, i replaced them and it was perfect. I would doubt they just run O rings in the cylinders, they will be propper seals on the piston, i can't guess what style though. The rods will use a propper pressure seal. If you pull the rams down, take it to a hydraulic seal shop and they can match them for you. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
creaping 610
Top