Reply to thread

Message: <blockquote data-quote="Clone" data-source="post: 93655" data-attributes="member: 13049"><p>OK I have not ordered the bushings or seals yet. I have been using the machine more to make sure I find all the problems and order all necessary parts. I have more info on this jerky situation. It is very bad with the boom up dumping into a truck. When I tilt the bucket down with the boom up and let the cylinders bottom out shaking the dirt out, you about have to let go of the sticks, then re-grab. Just driving in general with the loader up makes the jerkiness way worse. Does all of that still point to the rear centering plate bushings? Also I have a problem at times with the tilt cylinders not holding maybe 20% of the time. It is very random but seems the worst when I don't snap the valve back closed. If I am slowly rolling the bucket back, that is usually when the tilt will not hold. I know people usually say rebuild the cylinders but something to me says this is a check valve or valve issue. Any ideas on this?</p></blockquote><p></p>