Reply to thread

Message: <blockquote data-quote="Mike10" data-source="post: 90707" data-attributes="member: 5461"><p>Sounds like you have play in the linkage yet. It will not be the pivot bushings on your levers. There is a bushing on the other end of the yellow plate where it attaches to the engine bell housing which can wear allowing the plate to move laterally when the levers are stroked. You also need to remove that plate so you can make sure the levers are actually tight on the hydro shafts...........To replace the seals, remove the plate, the levers and the two screws holding down the plate over the seal. Remove the seal and install a new one.</p></blockquote><p></p>